Fujitsu M10 - Appendix A Troubleshooting; A.1 Understanding the Usual Problems and Their Corrective Actions

Table A-1
List of problem case examples
Case Possible cause Corrective action
The input power cannot be turned
on.
The power cord is disconnected. Connect the power cord correctly.
The breaker on the distribution
board is turned off.
Turn on the breaker.
The system management terminal
does not display the login prompt.
The serial cable is not connected to
the serial port.
Connect the serial cable correctly to
the serial port of the chassis.
See Figure 5-1 in "5.1 Connecting
Cables to the SPARC M10-1."
See Figure 5-4 in "5.2 Connecting
Cables to the SPARC M10-4/SPARC
M10-4S."
For a building block configuration,
connect the serial cable to the serial
port of the chassis whose MASTER
LED of the
XSCF unit is lit.
Appendix A
Troubleshooting
This appendix describes the corrective actions for problems that may occur during
installation work on the SPARC M10 systems.
■
Understanding the Usual Problems and Their Corrective Actions
■
Understanding Commands for Troubleshooting
■
How to Restore a BB-ID from an Incorrect Setting
A.1 Understanding the Usual Problems
and Their Corrective Actions
If operation is not normal during installation work, you may wonder whether there
was a failure. In such cases, inspect the following items and take corrective measures
accordingly.
297