Fujitsu M10 - 6.7 Performing a Diagnosis Test

.
XSCF>

settimezone

-c

settz

-s

Asia/Tokyo
Asia/Tokyo
XSCF>

showdate
Sat

Oct

20

14:53:00

JST

2012
XSCF>

setdate

-s

102016592012.00
Sat

Oct

20

16:59:00

JST

2012
The

XSCF

will

be

reset.

Continue?

[y|n]

:
y
Sat

Oct

20

7:59:00

UTC

2012
XSCF>
Note -
If the reboot is canceled, the XSCF does not reflect the setting values even when reboot
is by the rebootxscf command.
Note -
The PSB is powered on and off during the diagnosis test.
For power-on during the diagnosis test, CPU Activation keys do not need to have been
registered.
3.
To set the time zone, execute the settimezone command.
The following example sets the time zone to "Asia/Tokyo."
4.
Execute the show date command to display the XSCF time.
If you have set the time zone, the command displays the time in the local time
(JST).
The following example displays the current time in
the local time.
5.
If the time is correct, skip step 5 and subsequent steps. To change the date
and time, execute the setdate command.
Setting the date and time resets the XSCF.
The following example sets the local time (JST) to 16:59:00 October 20, 2012.
6.
Log in to the XSCF again
.
For details, see "6.3 Logging In to the XSCF."
6.7 Performing a Diagnosis Test
This section describes the procedure for performing an initial diagnosis of the
specified physical system board (PSB) while the power is off.
Chapter 6 Performing an Initial System Diagnosis 187