Fujitsu M10 User Manual

bb#00-if#2

address

[169.254.1.17

]

>

[Enter]

key
bb#01-if#2

address

[169.254.1.18

]

>

[Enter]

key
XSCF>

showroute

-a
Destination

Gateway

Netmask

Flags

Interface
Destination

Gateway

Netmask

Interface
XSCF>

setroute

-c

add

-n

address

-g

address

interface
XSCF>

setroute

-c

add

-n

0.0.0.0

-g

192.168.1.1

bb#00-lan#0
XSCF>

setroute

-c

add

-n

0.0.0.0

-g

192.168.2.1

xbbox#80-lan#1
7.5.5 Setting the routing
1.
Execute the showrout e command to display the routing environment.
2.
Execute the setroute command to set the default gateway.
For -n address, specify the IP address that is the routing information destination.
If 0.0.0.0 is specified in address , the command sets the default routing information.
For -g address, specify the gateway address used in routing.
For interface, specify the network interface to be set. You can specify it as follows
depending on the system configuration:
- SPARC M10-1/M10-4/M10-4S (no crossbar box): bb#00-lan#0, bb#00-lan#1,
bb#01-lan#0, bb#01-lan#1
- M10-4S (with crossbar boxes): xbbox#80-lan#0, xbbox#80-lan#1, xbbox#81-
lan#0, xbbox#81-lan#1
The following
example adds the default gateway IP address 192.168.1.1 for
XSCF-LAN#0 of BB#00.
The following example adds the default gateway IP address 192.169.1.1 for
XSCF-LAN#1 of XBBOX#80.
7.5.6 Applying network settings
To complete configuration of the network, settings must be reflected and the XSCF
must be reset. The XSCF reset disconnects the XSCF session, so log in again.
1.
Execute the applynetwork command on the XSCF shell.
Execution of the command displays the network settings, so you can confirm the
Chapter 7 Making the Initial System Settings 211

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English