Fujitsu M10 User Manual

XSCF>

applynetwork
The

following

network

settings

will

be

applied:

bb#00

hostname

:scf0-hostname

bb#01

hostname

:scf1-hostname

DNS

domain

name

:example.com

interface

:bb#00-lan#0

status

:up

IP

address

:192.168.1.x

netmask

:255.255.255.0

route

:-n

0.0.0.0

-m

0.0.0.0

-g

192.168.1 .1

interface

:bb#00-lan#1

status

:down

IP

address

:192.168.2.a

netmask

:255.255.255.0

route

:-n

0.0.0.0

-m

0.0.0.0

-g

192.168.2 .1


Omitted
Continue?

[y|n]

:
y
Please

reset

the

all

XSCFs

by

rebootxscf

to

apply

the

network

settings.
Please

confirm

that

the

settings

have

been

applied

by

executing
showhostname,

shownetwork,

showroute,

showsscp

and

shownameserver

after
rebooting

the

all

XSCFs.
XSCF>

rebootxscf

-a
The

XSCF

will

be

reset.

Continue?

[y|n]

:
y
settings made.
2.
Execute the rebootxscf command to reset the XSCF and complete the settings.
Execution of the command disconnects the XSCF connection.
The setting work from this step can be done through an XSCF-LAN connection
too.
To switch from a serial connection to an XSCF-LAN connection, connect to the
XSCF by specifying its IP address on a PC connected to the XSCF-LAN, and log
in again.
3.
Execute the showho stnam e, shownetwork, showsscp, and showroute
commands again to display the network settings, and confirm the new
network information.
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015212

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English