Fujitsu M10 User Manual

Table 1-1
Workflow for the SPARC M10-1 (continued)
Step (work time (*1)) Work description Reference
2 Before installing the system, check
the safety precautions, system
specifications, and necessary
conditions for installation.
"Chapter 2 Planning and Preparing
for System Installation"
Required
3 Prepare the necessary tools/
information for installation.
"3.1 Preparing the Necessary
Tools/Information for Installation"
Required
4 Confirm the delivered components. "3.2.1 Confirming the delivered
components of the SPARC M10-1"
Required
5Install the rack. See the manual for each rack.
"3.3.2 Securing the rack"
Required
6Mount the chassis in the rack. "3.4.1 Mounting the SPARC M10-1
in a rack"
Required
7If there are optional components,
mount them on the chassis.
"3.5.1 Mounting optional
components in the SPARC M10-1"
Optional
(*3)
8Connect serial cables, LAN cables,
and power cords to the chassis.
"5.1 Connecting Cables to the
SPARC M10-1"
Required
Initial diagnosis (approx. 30 minutes)
9Connect the system management
terminal to the chassis, and turn on
the input power.
"6.1 Connecting the System
Management Terminal to the Chassi
s"
"6.2.2 Turning on the input power
and starting
the XSCF"
Required
10 Log in to the SPARC M10-1, and
check the firmware version number,
altitude setting, and time setting.
"6.3 Logging In to the XSCF"
"6.4 Checking the XCP Version"
"6.5 Checking the Altitude Setting"
"6.6 Checking the Time Setting"
Required
11 Perform an initial diagnosis test on
the physical
system board (PSB).
"6.7 Performing a Diagnosis Test"Required
12 Check the status of mounted
components.
"6.8 Checking the Component
Status"
Required
Initial system settings (approx. 50 minutes)
13 Set the password policy. "7.1 Setting the Password Policy"Required
14 Set a user account and password. "7.2 Setting a User Account and
Password"
Required
15 Configure the telnet or
SSH service. "7.3 Configuring the Telnet/SSH
Service"
Required
16 Configure the HTTPS service. "7.4 Configuring the HTTPS
Service"
Required
17 Configure the XSCF network. "7.5 Configuring the XSCF
Network"
Required
18 When duplicating memory,
configure memory mirroring.
"7.6 Configuring Memory
Mirroring"
Optional
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 20152

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English