Fujitsu M10 - Page 229

XSCF>

showpcl

-p

0
PPAR-ID

LSB

PSB

Status
XSCF>

setpcl

-p

0

-a

0=00-0
XSCF>

setpcl

-p

1

-a

0=01-0

1=02-0

2=03-0
XSCF>

setpcl

-p

ppar_id

-s

policy=
value
XSCF>

setpcl

-p

0

-s

policy=system
XSCF>

setpcl

-p

1

-s

policy=system
XSCF>

showpcl

-a

PPAR-ID

LSB

PSB

Status

00

Powered

Off


00

00-0

----------------------------

01

Powered

Off


00

01-0


01

02-0


02

03-0
2.
Execute the setpcl command to create a physical partition configuration list
(PCL).
The following example maps system board 00-0 to logical system board 0 of
physical partition 0.
The following example maps system boards 01-0, 02-0, and 03-0 to logical system
boards 0, 1, and 2, respectively, of physical partition 1.
3.
Execute the setpcl command to set the configuration policy for all physical
partitions as a whole.
In value, specify fru (part), psb (system board), or system (all physical partitions
as a whole) as the degradation unit. The default setting is fru.
The following example sets the configuration policy to "All physical
partitions"
for physical partitions 0 and 1.
4.
Execute the show pcl command, and confirm the set physical partition
conf iguration list (PCL).
Chapter 7 Making the Initial System Settings 215