Fujitsu M10 User Manual

XSCF>

showdate
Sat

Oct

20

14:53:00

JST

2012
XSCF>

showdateoffset

-p

0

PPAR-ID

Domain

Date

Offset
00

0

sec
XSCF>

resetdateoffset

-p

0

Clear

the

offset

of

PPAR-ID

0?

[y|n]

:
y

XSCF>
7.10 Synchronizing the Physical Partition
(PPAR) Time and XSCF Time
This section describes the procedure for clearing the difference between the system
time and physical partition (PPAR) time.
The XSCF keeps the time difference from the physical partition. With each change by
setdate command to the system time, the difference is updated with the difference
between the physical partition time and
the changed system time.
To initialize the time difference between all physical partitions and the XSCF, execute
the resetdateoffset command on the XSCF. This command synchronizes the physical
partition times after physical partition startup with the XSCF time.
1.
Execute the show date command to display the XSCF time.
If you have set the
time zone, the command displays the time in the local time
(JST).
The following example displays the current time in the local time.
2.
Confirm that the set XSCF time is correct. To change the date and time,
execute the setdate command.
For details, see "6.6 Checking the Time Setting."
3.
Execute
the show dateoffset command to check the times difference between
the XSCF system time and physical partition time.
The following example displays the difference between the system time and the
time of PPAR-ID 0.
4.
Unless the time difference in step 3 was 0 seconds, execute the resetdateoffset
command to initialize the difference between the XSCF system time and the
time of the physical partition.
The time of each physical partition is set to the XSCF system time at the next
physical partition startup.
Chapter 7 Making the Initial System Settings 219

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English