Fujitsu M10 User Manual

XSCF>

poweroff

-y

-a
procedure, see "3.7.15 Reflecting the XSCF network settings" in the Fujitsu
M10/SPARC M10 Systems System Operation and Administration Guide.
3.
Execute the poweroff command to stop the system.
4.
Remove the power cords of all the chassis from the input power.
5.
Connect the power cords to the PDU mounted in expansion
rack 2.
For details, see "3.3.1 Connecting the power cords to the power distribution
units of an expansion rack."
6.
Connect expansion racks 1 and 2.
For details, see "3.3.3 Connecting racks."
7.
Fix expansion rack 2 in place.
For details, see "3.3.2 Securing the rack."
8.
Add a cross bar unit to
the cros sbar boxes (BB#80, BB#81) mounted in
expansion rack 1.
For details, see "Chapter 12 Maintaining the Crossbar Units" in the Crossbar Box
for Fujitsu M10/SPARC M10 Systems Service Manual.
9.
Mount the target SPARC M10-4S in the expansion rack.
For details, see "3.4.2 Mounting the SPARC M10-4/SPARC M10-4S in a rack
."
10.
Reattach the labels of the crossbar cables, and replace the cables.
For details, see "4.3.1 Changing crossbar cables (when subsequently installing
expansion rack 2)."
11.
Connect the cros sbar cables and XSCF BB control cables to each chassis.
Crossbar cables (optical) and XSCF BB control cables are already laid in the
expansion
rack. The work here is to connect the cables to each port of the
mounted chassis. Connect the cables according to the instructions written on the
labels.
For a cable connection diagram and a cable list, see "B.5 9BB Configuration to
16BB Configuration (Connections through Crossbar Boxes)."
12.
Connect the cros sbar
cables and XSCF BB control cables that pass between
the racks.
For details, see "4.3.2 Connecting crossbar cables" and "4.3.3 Connecting
XSCF cables."
13.
Set the ID of the SPARC M10-4S.
For details, see "4.1 Setting the ID (BB-ID) Identifying a Chassis."
14.
Connect serial cables and LAN cables to
a crossbar box.
For details, see "5.2 Connecting Cables to the SPARC M10-4/SPARC M10-4S"
and "5.4 Connecting Cables to a Crossbar Box."
15.
Connect the power cords to the SPARC M10-4S.
16.
Connect the system management terminal to the cross bar box of the mast er
XSCF, and then perform an initial diagnosis
of the system.
For details, see "Chapter 6 Performing an Initial System Diagnosis."
Fujitsu M10/SPARC M10 Systems Installation Guide
･
July 2015270

Fujitsu M10 Specifications

General

Brand	Fujitsu
Model	M10
Category	Server
Language	English