16 U41615-J-Z156-1-76
Notes on Safety Important Notes
Before Setting up
V CAUTION!
● During installation and before operating the device, observe the
instructions on environmental conditions for you device (see section
“Technical Data” on page 10).
● If the device is brought in from a cold environment, condensation may
form both inside and on the outside of the machine.
Before operating the device, wait until it is absolutely dry and has
reached approximately the same temperature as the installation site.
Failure to observe these guidelines can lead to material damage of
the device.
● Transport the device only in the original packaging or in a packaging
which protects it from knocks and jolts.
Installation and Operation
V CAUTION!
● If the server is integrated in an installation that receives power from
an industrial (public) power supply network with the IEC309
connector, the (public) power supply protection must comply with the
requirements for the non-industrial (public) power supply networks for
the type A connector.
● The server automatically adjusts to a mains voltage between 100 V -
127 V or 200 V - 240 V. The server may be place in operation only, if
the mains voltage range set on the server corresponds to the local
mains voltage.
● This device has a specially approved power cable and must only be
connected to a grounded insulated socket.
● The ON/OFF button does not disconnect the device from the mains
voltage. To completely disconnect it from the mains voltage, remove
the power plug from the insulated socket.
● Always connect the device and the attached peripherals to the same
power circuit. Otherwise you run the risk of losing data if, for example,
the central processing unit is still running but the peripheral device
(e.g. storage subsystem) has failed during a power outage.
To Next Page
Loading...
Need help?
General