44 U41615-J-Z156-1-76
Switching the Server ON/OFF Preparation for Use/Operation
5.2 Switching the Server ON/OFF
The ON and OFF indicators and operating elements may be found in figure 8 on
page 39 with the associated table on page 39.
V CAUTION!
If after switching ON the server there is nothing but flickering stripes on
the screen, switch the server OFF immediately (see chapter “Problem
Solutions and Tips” on page 51).
The ON/OFF button does not disconnect the server from the mains
voltage. To completely disconnect it, you must pull the power plug.
Switching the server ON
– First system installation:
Ê Press the ON/OFF button.
Ê Insert the ServerStart CD and/or an installation disk into the corre-
sponding drive.
Ê Follow the instructions on the monitor (see also section “Configuring the
Server” on page 46).
– System already installed:
Ê Press the ON/OFF button.
The server is switched ON, performs a system test and boots the
operating system.
Switching the server OFF
Power-on indicator lights up green.
Ê Shut down the operating system in an orderly manner.
The power-on indicator lights up amber.
Ê Press the ON/OFF button and/or send a corresponding control signal (see
“Other ON/OFF possibilities” on page 45).
The server switches OFF.
To Next Page
Loading...
Need help?
General