U41615-J-Z156-1-76 51
6 Problem Solutions and Tips
V CAUTION!
Observe the safety information in the ”Safety“ manual and in chapter
“Hardware Installation” on page 25.
If a problem occurs, try to resolve it as described:
– in this chapter,
– in the documentation for the attached devices,
– in the help systems of the software used.
If you fail to correct the problem, proceed as follows:
Ê Make a note of the steps and the circumstances that led to the fault. Note
also any error message which may have been displayed.
Ê Switch the server OFF.
Ê Contact our Service organization (see “Warranty” in chapter “Related publi-
cations” on page 63).
6.1 Power-ON Indicator Remains Dark
The power-ON indicator remains dark after switching ON:
Power cable not connected correctly
Ê Make sure that the power cable is correctly connected to the server and to
the grounded power socket.
Power supply overloaded
Ê Pull the server power plug out of the insulated socket.
Ê Wait a few seconds and plug the power plug into the insulated socket again.
Ê Switch your server ON.
To Next Page
Loading...
Need help?
General