U41615-J-Z156-1-76 27
Hardware Installation Installing/Removing the Server into/from the Rac
4.3 Installing/Removing the Server into/from
the Rack
V CAUTION!
● Please note the safety instructions in chapter “Important Notes” on
page 15 and in section “Notes on Installing the Rack” on page 22.
● The rack can tip over when more than one slide-in unit is pulled out.
V CAUTION!
There is no cable management for the server in the rack!
Before the server is removed, all cables must be disconnected from the
sockets. Please proceed as follows:
– Terminate all applications and shut down the operating system.
– Switch off the server.
– Disconnect and remove all cables connected to the server.
– Remove the server from the rack.
To Next Page
Loading...
Need help?
General