22 U41615-J-Z156-1-76
Notes on Installing the Rack Important Notes
3.5 Notes on Installing the Rack
● When connecting and disconnecting cables, observe the relevant notes in
the chapter ”Important notes“ in the Technical Manual for the corresponding
rack. The Technical Manual is supplied with the corresponding rack.
● Ensure that the anti-tilt bracket is correctly mounted when you set up the
rack.
● For safety reasons, only one unit should be withdrawn from the rack at any
one time.
● If several units are withdrawn at the same time from the rack there is a
danger that the rack will tilt forward.
● The power connection for the rack must be installed by an authorized
technician (electrician).
● If the rack model is integrated in an installation that receives power from an
industrial (public) power supply network with the IEC309 connector, the
(public) power supply protection must comply with the requirements for the
non-industrial (public) power supply networks for the type A connector.
3.6 Environmental Protection
Environmentally friendly product design and development
This product has been designed in accordance with standards for ”environmen-
tally friendly product design and development“. This means that the designers
have taken into account important criteria such as durability, selection of
materials and coding, emissions, packaging, the ease with which the product
can be dismantled and the extent to which it can be recycled.
This saves resources and thus reduces the harm done to the environment.
Notes on saving energy
Devices that do not have to be on permanently should not be switched on until
they need to be used and should be switched off during long breaks and on
completion of work.
To Next Page
Loading...
Need help?
General