135
PRIMERGY RX100 S3 User’s Guide
5
Operations after OS Installation
● Kernel Memory Dump
Information of only kernel memory space is recorded. The file is stored in the directory displayed in the
[Dump file] box. Capacity required for kernel memory dump is as follows:
• Paging file: Depending on installed physical memory amount
For memory of 256 to 1,373MB - Installed physical memory x 1.5
For memory of 1,374MB or more - 32-bit system: 2GB + 16MB, 64-bit system: Installed physical
memory + 128MB
• Memory dump file: Depending on the used amount of kernel-mode address space during STOP
● Small Memory Dump
Minimum amount of useful information for problem identification is recorded. If this option is specified,
a new file is created each time the system unexpectedly stops.
History of such files is stored in the directory displayed in [Small dump directory].
• Paging file: 2MB or more
• Memory dump file: 64KB or 128KB
■ Memory Dump File Setting
Set up the memory dump file according to the following procedures:
1 Log on to the server with administrator privileges.
2 Check free space of the drive where the memory dump file is to be stored.
Check the required amount of free space according to "■ Checking Hard Disk Free Space"
(pg.134).
If the drive has no free space, refer to "
■ Cannot Collect the Memory Dump" (pg.250).
3 Click [Start] → [Control Panel] → [System].
The [System Properties] window appears.
To Next Page
Loading...
Need help?
General