Fujitsu Primergy RX100 S3 - Creating a DOS Floppy Disk

152
Chapter 5 Operations after OS Installation
5.4.2 Creating a DOS Floppy Disk
For DOS data stored into the floppy disk, refer to the file in the following folder of the ServerStart Disc
1 CD-ROM.
[CD-ROM drive] :\FreeDOS
To create a DOS floppy disk, you need an unused floppy disk. Prepare it in advance.
If ServerStart has already been started, it is not necessary to restart it. If it has not, start it up according to
the following procedures:
1 Start up ServerStart and click [FloppyBuilder].
For details on procedures for starting up ServerStart, refer to "■ Starting ServerStart" (pg.149).
2 Click [DOS Diskette].
Insert the prepared floppy disk by following the message.
3 Perform the subsequent operations according to the messages on the window.
The floppy disk will be formatted automatically and file copying will start.
The DOS floppy disk will be created automatically. When a message appears indicating that the
disk is created, click [OK] and eject the disk.