Fujitsu Primergy RX100 S3 User Manual

153
PRIMERGY RX100 S3 User’s Guide
5
Operations after OS Installation
5.5 Notes Before Operating the
Server
This section explains the settings required before starting to operate the server.
 For details on the settings, refer to the following URL.
http://www.microsoft.com/technet/prodtechnol/exchange/2003/Library/default.mspx
• If a LAN card was added, install a driver according to "4.3 Installing the LAN Driver" (pg.127).
• When connecting a SCSI optional device (such as a hard disk cabinet or DAT), connect it according
to "Chapter 7 Installing Internal Options" (
pg.175).
• For the settings for the installed applications supplied with the product, refer to the manuals of each
application.
5.5.1 Auto-run Function from CD-ROM Drives
Perform the following procedures to change the settings of the auto-run function from the CD-ROM
drives after server installation:
1 Make the registry editable, and change the value of AutoRun of the following
registry key:
HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\CDRom
Set the value of Autorun to "1" to enable auto-run, and set the value to "0" to disable auto-run.
2 Restart the system.
The setting is enabled after the system is restarted.

Fujitsu Primergy RX100 S3 Specifications

General

Brand	Fujitsu
Model	Primergy RX100 S3
Category	Server
Language	English