Fujitsu Primergy RX100 S3 User Manual

140
Chapter 5 Operations after OS Installation
• Included information
Common header, minidump header, kernel module, memory information, processor information,
process information, thread information, stack page, unloaded module information
• Required size
2MB or more
■ Memory Dump File Setting
Set up the memory dump file according to the following procedures:
1 Log on to the server with administrator privileges.
2 Check free space of the drive where the memory dump file is to be stored.
Check the required amount of free space according to "■ Checking Hard Disk Free Space"
(pg.139).
If the drive has no free space, refer to "
■ Cannot Collect the Memory Dump" (pg.250).
3 Click [Start] → [Settings] → [Control Panel].
4 Double-click the [System] icon.
The [System Properties] window appears.
5 Click the [Advanced] tab and click [Startup and Recovery].
The [Startup and Recovery] window appears.
6 Set as follows:
1. In the [Write debugging information] section, select the memory dump file type.
• Complete memory dump (Recommended)
The whole system memory information is recorded to the memory dump file.
• Kernel memory dump
Only kernel memory is recorded to the memory dump file.
• Small memory dump (2MB or more)

Fujitsu Primergy RX100 S3 Specifications

General

Brand	Fujitsu
Model	Primergy RX100 S3
Category	Server
Language	English