Fujitsu Primergy RX100 S3 - Page 210

210
Chapter 8 Configuring Hardware and Utilities
ATA Controller Config Press the [Enter] key to display the [ATA Controller Config] submenu.
P-ATA Maps To Primary (Unchangeable) Sets the parallel ATA mapping.
Primary IDE
Channel
Enabled (Unchangeable)
Sets whether or not to enable primary IDE channel.
Secondary IDE
Channel
Enabled (Unchangeable)
Sets whether or not to enable secondary IDE
channel.
Mouse Controller
Auto Detect (Initial value)
Sets whether or not to use the mouse connected to
the mouse port.
LAN Controller
• Disabled
• LAN 1
• LAN 1&2 (Initial value)
Sets whether to enable or disable the onboard LAN
controller.
LAN 1 Remote Boot
• Disabled (Initial value)
•PXE
Sets whether or not to perform a network boot.
This function allows booting the server via the
network. It is used for remote installation of the OS,
etc.
You can set this item only when [LAN Controller]
is set to [LAN1] or [LAN 1&2].
LAN 2 Remote Boot
• Disabled (Initial value)
•PXE
Sets whether or not to perform a network boot.
This function allows booting the server via the
network. It is used for remote installation of the OS,
etc.
You can set this item only when [LAN Controller]
is set to [LAN 1&2].
SCSI Controller
Enabled (Unchangeable)
Sets whether to enable or disable the onboard SCSI
controller.
SCSI Option ROM Scan
Enabled (Unchangeable)
Sets whether or not to initialize the extended ROM.
table: Items on the Peripheral Configuration Submenu
Item Setting Description