Fujitsu Primergy RX100 S3 - Page 231

231
PRIMERGY RX100 S3 User’s Guide
8
Configuring Hardware and Utilities
3 When the DOS prompt is displayed, enter the following command and press
the [Enter] key.
A:\SMT\>ASPIFMT.EXE
The SCSI Low-Level Format Utility starts up.
4 Use the [↑] [↓] keys to select the hard disk to be formatted physically. Press the
[Space] key to set it.
5 Press the [Tab] key to move to the [Format] button. Press the [Space] key.
A confirmation message is displayed.
6 Read the message, select [Format] again, and press the [Space] key.
Physical formatting starts.
When the physical formatting completes, a completion message appears.
7 Check that [Failed Formatting Drive(s)] indicates "none". Select [Exit] and press
the [Space] key.
8 Select [Exit] again and press the [Space] key.
The physical formatting has completed when the DOS prompt appears.
The server can be turned off.