121
PRIMERGY TX150 S4 User’s Guide
4
Manual OS Installation
4 The [Windows Server 2003 x64 Setup] window appears.
Immediately, the following message appears at the bottom of the window. Press the [F6] key.
` This message will be displayed for a short time after the setup window (blue screen) appears.
Press the [F6] key immediately after the window turns blue.
5 When configuring the array system using the SCSI array controller card, install
the Drivers for SCSI array controller card manually.
1. When the following message appears, press the [S] key.
2. When the "Please insert the disk labeled Manufacturer-supplied hardware support
disk into Drive A:" message appears, insert the driver disk created from the driver’s
CD and press the [Enter] key.
The following message appears.
3. Select following item and press the [Enter] key.
4. When the following message appears, press the [S] key.
5. Follow the instructions in the window to perform installation
The message which prompts you to set the floppy disk appears during the installation, set
the driver disk and push the [Enter] key.
6 Follow the instructions from the setup program to continue the installation
procedure.
If a message indicating that the driver has not passed Windows Logo testing to verify its
compatibility with Windows appears, select [Yes] to continue the installation procedure.
Press F6 if you need to install a third party SCSI or RAID
driver ...
To specify additional SCSI adapters, CD-ROM drives, or
special disk controllers for use with Windows, including
those for which you have a devicesupport disk from a mass
storage device manufacturer, press S.
You have chosen to configure a SCSI Adapter for use with
Windows, using a device support disk provided by an
adapter manufacturer.
Select the SCSI Adapter you want from the following list,
or press ESC to return to the
previous screen.
MEGARAID SCSI 320-0X RAID Controller Drive
The driver you provided seems to be newer than the Windows
default driver. Windows already has a driver that you can
use for "MEGARAID SCSI 320-0X RAID Controller Driver"
Unless the device on the floppy disk, you should use the
driver in Windows.
To Next Page
Loading...
Need help?
General