168
Chapter 5 Operations after OS Installation
3 Specify [VLAN ID] and [VLAN Name] in the [Create New VLAN] window.
The [VLAN ID] should be identical with the switch setting.
The [VLAN Name] does not need to be identical with the switch setting.
` You cannot use a "VLAN ID" or "VLAN Name" that has already been used. Enter another set
value.
4 When the setting for the team is completed, click [OK].
5 Click [Apply] to apply the settings.
After the network is temporarily disconnected, a window is displayed. Click [Yes (Y)].
5.6.3 Cautions for Onboard LAN Driver Ver8.39.1.0
■ Event Log
Once a Team and VLAN are setup, multiple logs that start with the following log may be stored in the
system log file of the event viewer at system start-up.
Since such event logs will be stored even if the Teaming function and VLAN function are operated
normally, ignore them.
Source Blfm
ID
8
Type Error
Description Could not bind to adapter \DEVICE\{(adapter name)}.
* (adapter name) varies depending on the OS or hardware
configuration.
To Next Page
Loading...
