52
Chapter 2 Checking before OS Installation
2.3.5 Expansion Cards Supported by ServerStart
ServerStart supports automatic driver installation for the following expansion cards.
2.3.6 Cautions for Manual Installation
■ Notes on Using a SCSI Array Controller Card
Before the OS is installed, the SCSI array controller card must be configured and the system drive under
the SCSI array controller card must be initialized. To check the SCSI array controller card settings, start
up WebBIOS. For more details, refer to the manual which comes with the SCSI array controller card.
■ Installing Windows 2000 Server
To install Windows 2000 Server directly, you have to use Service pack 4 integrated OS media or install
Service Pack 4 or newer Service Pack.
And please install hotfix module named KB904374 after OS installation.
Please find out hotfix module of your language version from the following folder on ServerStart CD.
[CD-ROM drive]: \HOTFIX\W2K\
■ Free Space Required for Installation
The partition where the OS is installed must have enough free space for obtaining memory dump. For
more details, refer to"5.1 Memory Dump/Paging File Setting" (
Jpg.142).
■ Cautions on Restarting
In the course of installation, a message appears to indicate that the setup program restarts. Wait until it
restarts automatically.
For background operations, refer to "Onboard SCSI RAID User’s Guide" or the manual which comes
with the SCSI array controller card.
table: Automatic Expansion Card Driver Installation
Name Model Bus
Onboard FDD/IDE - -
SCSI array controller card PG-140D1 PCI
Onboard LAN -
PCI-E
Onboard VGA - PCI
LAN Card PG-1852 PCI
PG-1892 PCI
PG-2861 PCI-E
SCSI Ctrl U160 PG-128 PCI
SCSI Ctrl U160 w PG-129B PCI
To Next Page
Loading...
Need help?
General