EasyManuals Logo

Fujitsu primergy TX150 User Manual

Fujitsu primergy TX150
305 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #151 background imageLoading...
Page #151 background image
151
PRIMERGY TX150 S4 User’s Guide
5
Operations after OS Installation
6 Click [Change] in the [Virtual memory] section.
The [Virtual Memory] window appears.
7 Specify the drive where the paging file is to be created.
In [Drive], select the drive where the system is installed.
The selected drive is displayed in [Drive] in [Paging file size for selected drive].
8 Specify the [Initial size].
The value depends on the type of the set dump file.
Specify a value larger than the value shown in [Recommended] in [Total paging file size for all
drives].
` When a smaller value is specified for the paging file size, performance may be affected. We
recommend to specify the paging file size larger than the recommended value.
9 Specify the [Maximum size].
Specify a value larger than the [Initial size].
10 Save the settings.
Click [Set] in the [Paging file size for selected drive] section.
The settings are saved, and the value specified is displayed in [Paging File Size] of [Drive].
11 Click [OK] to close the [Virtual Memory] window.
12 Click [OK] to close the [Performance Options] window.
13 Click [OK] to close the [System Properties] window.
14 Restart the system.
The setting is enabled after the system is restarted.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Fujitsu primergy TX150 and is the answer not in the manual?

Fujitsu primergy TX150 Specifications

General IconGeneral
BrandFujitsu
Modelprimergy TX150
CategoryServer
LanguageEnglish

Related product manuals