225
PRIMERGY TX150 S4 User’s Guide
8
Configuring Hardware and utilities
USB Enable Ports • None
• All (Initial value)
Sets whether or not to use the USB port.
USB 2.0 Host Controller
•Disabled
• Enabled (Initial value)
Sets whether or not to enable the USB controller
(2.0 standard).
You can set this item only when [USB Enable Ports]
is set to [All].
USB BIOS Supported
Devices
Auto (Unchangeable)
Sets whether the USB device can be used on the OS
that does not support USB.
USB Boot Delay Os (Unchangeable)
Sets the delay time by the second for initializing
USB mass storage device during the POST.
ATA Controller Config Press the [Enter] key to display the [ATA Controller Config] submenu.
P-ATA Maps To Primary (Unchangeable)
Sets the parallel ATA mapping.
Primary IDE Channel
Enabled (Unchangeable) Sets whether or not to enable primary IDE channel.
Secondary IDE
Channel
Enabled (Unchangeable) Sets whether or not to enable secondary IDE
channel.
Diskette Controller
Enabled (Unchangeable)
Configures the floppy disk controller.
Mouse Controller
Auto Detect (Initial value)
Sets whether or not to use the mouse connected to
the mouse port.
LAN Controller
•Disabled
• Enabled (Initial value)
Sets whether to enable or disable the onboard LAN
controller.
LAN Remote Boot
• Disabled (Initial value)
•Enabled
Sets whether or not to perform a network boot.
This function allows booting the server via the
network. It is used for remote installation of the OS,
etc.
You can set this item only when [LAN Controller]
is set to [Enabled].
SCSI Controller
Enabled (Unchangeable)
Sets whether to enable or disable the onboard SCSI
controller.
SCSI Option ROM Scan
Enabled (Unchangeable)
Sets whether or not to initialize the extended ROM.
table: Items on the Peripheral Configuration Submenu
Item Setting Description
To Next Page
Loading...
Need help?
General