233
PRIMERGY TX150 S4 User’s Guide
8
Configuring Hardware and utilities
System Password Mode • System (Initial value)
• Keyboard
Sets the password entering for system start-up. You
can set this item only when [System Password] is
specified.
•System
The password entry screen is displayed when the
system is started. You can unlock the system
with the password.
• Keyboard
A password is not required. Keyboard and mouse
are locked to prevent the operation. You can
unlock the system by entering the password on
the keyboard and pressing the [Enter] key.
System Password Lock • Standard
• WOL Skip (Initial value)
Sets whether or not to skip entering the password
when the system is started with Wakeup on LAN.
You can set this item only when [System Password
Mode] is set to [System].
System Load • Standard (Initial value)
• Diskette/CDROM Lock
Sets whether to enable or disable system startup
from a floppy disk or CD-ROM.
Setup Prompt • Disabled
• Enabled (Initial value)
Sets whether or not to display a setup message
"<F2>BIOS Setup/<F12>BOOT Menu" on the
[POST] window during system startup.
Virus Warning Disabled (Fixed parameter) Sets whether or not to check the boot sector of the
hard disk drive after the previous system startup. If
the boot sector is changed without a clear reason, it
is necessary to scan the system for computer viruses
with a virus detection program.
Diskette Write • Disabled
• Enabled (Initial value)
Sets whether or not to allow writing on a floppy
disk.
Flash Write • Disabled
• Enabled (Initial value)
Sets whether or not to allow writing on the BIOS
Flash ROM.
table: Items on the Security Menu
Item Setting Description
To Next Page
Loading...
Need help?
General