Setting Up iX100
Set up the ScanSnap so that it is ready to scan with ScanSnap Manager.
The following preparations are required before you set up the ScanSnap.
l Check that all items are included in the package
For details, refer to "Package List for iX100" (page 35).
HINT
When Getting Started is included in the package, refer to "Package List" in Getting Started.
l Remove the tape seal (1) and tape (2) from the ScanSnap
l Connect the ScanSnap and the computer with a USB cable, and charge the battery until the
battery indicator light turns off
ATTENTION
- Do not open the feed guide until the instructions are displayed on the window for installing
software.
- The ScanSnap can be charged with the supplied USB cable or optional USB power adapter.
For details about purchasing the USB power adapter, refer to "Suppliers of Consumables/
Optional Parts" in "About Customer Support and Maintenance" (page 514).
The procedure to set up the ScanSnap is as follows:
1. Downloading the Software
2. Installing the Software/Connecting the ScanSnap
3. Checking the Scanning Operation
Setting Up iX100
31