Setting Up iX1600 / iX1500 / iX1400
Set up the ScanSnap so that it is ready to scan with ScanSnap Manager.
The following preparations are required before you set up the ScanSnap.
l Check that all items are included in the package
For details, refer to "Package List for iX1600 / iX1500 / iX1400" (page 27).
l Remove the protective inner cover and tape (1) and the cardboard sheet (2) from the ScanSnap
The procedure to set up the ScanSnap is as follows:
1. Configuring the Settings of the ScanSnap
2. Downloading the Software
3. Installing the Software/Connecting the ScanSnap
4. Checking the Scanning Operation
Configuring the Settings of the ScanSnap
1. Connect the power cable to the power connector on the ScanSnap and the AC outlet.
Use only the AC adapter and cables that are bundled with the ScanSnap.
Using other adapters and cables may cause a scanner failure.
Setting Up iX1600 / iX1500 / iX1400
22