FULTON RBC1250 - 4.4 Gasket, Door, and Disperser Maintenance

RB-RBC-IOMM-2015-1
Fulton Ltd
Page 35
MAINTENANCE - 4
4.7 FITTING NEW GASKETS TO BOILER INSPECTION HOLES
4.7.1 IMPORTANT INFORMATION
TheRB/RBCseriesofboilersarettedwithTOPOG-Egasketsinalltheinspectionholesof
the boiler. These gaskets work very well and millions have been safely used over the last 30
years, however, it is absolutely essential to observe a few simple rules in order to get the best
performance from your installation.
Elastomeric Vulcanizates, which form the basis of TOPOG-E gaskets, undergo degradation
from many sources including heat, oxygen, stress, and overdosing from certain types of water
treatment. This takes the form of material oxidation, hardening/embrittlement and cracking which
may result in gasket failure. Steps must be taken to minimise the effects of such attacks.
Water treatment and oxygen attack can be minimised by ensuring that the gasket is aligned
correctly so that only the extreme edges of the gasket are exposed. If a new gasket leaks after
ttingthisisalmostcertainlyduetoincorrectseatingoralignment.Assuchgasketsarevery
exibleitispossibletocuretheleakbyexcessivetightening,butsuchanactionwillseriously
reduce the life of the gasket and cause problems later.
Unduestresscanbeavoidedbytighteningjustsufcientlytostopanyleakagewhenttingcold
andbeforeringtheboiler.Starttheboilerandgraduallybringituptoworkingtemperature,
allowing the increasing steam pressure to take over and complete the seal. This will allow the
gasket material to contract naturally and follow the topography of the mating surfaces. The
securingnutcanthenbetightenedgentlybyapproximatelyaquarterofaturn,toensurea‘snug’
tandpreventthesealfrombeingbrokenwhentheboileriscoldandundernegativepressure.
Gentlewarmingoftheboileroninitialringaftermaintenancewillalsohelptoensurethatthe
rubber ‘curestoshape’.Iftherubberpost-cures,theelasticmemorywillbedestroyedandany
initial over tightening will cause the gasket to become hardened and embrittled, leading to cracks
and eventual failure.
CAUTION
TOPOG-E gasket have a nite life after installation and must be renewed annually.
It is important that the instructions given in this section are adhered to.
!