Once the log is chosen and the ‘ENTER’ key is pushed (use ‘TAB’ key to move through them), the following
screen will appear. In the sample figure all of the possibilities are shown. Only one of the two words,
ON/OFF, will appear depending on which function is active:
This screen is the same one as the auxiliary screens of the measurements for this machine. The information
shown will not be able to be modified under any condition, it is only shown to inform the user. Once the
user has this information on the screen, by pressing the ‘ON’ key the measurement can begin and then the
measurement screen will be shown. If the ‘ENTER’ key is pressed the measurement configuration page is
accessed and if the key is pressed again, the status page appears.
Once on the measurement configuration screen, the measurement details can be seen but not modified.
Now if the ‘ON’ key is pressed, the measurement can begin.
If a log that has not been recorded previously is selected by mistake (the viscometer comes from the factory
with empty logs) and if the ‘ENTER’ key is pressed, a screen like the following will appear:
“X” being a log number from 1 to 9. If the following screen is visualized:
Means that the slot M3 would have been selected and it would be there without having been recorded on
(empty). By pressing the ‘ENTER’ key again, the log selection screen will reappear to be able to select
another log.
To Next Page
Loading...
