125
6 Modifications to the basic vehicle
6.13 Others
MITSUBISHI FUSO body/equipment mounting directives for FE Issue date: 20. 10. 2020
! Only print out complete sections from the current version
6.13.2 Advanced emergency braking system
(AEBS) <Vehicle with AEBS>
Advanced emergency braking system automatically
applies the brakes to either prevent a collision, or
reduce the speed at which impact occurs and thereby
reduce the damage caused by a collision when a
collision with the vehicle ahead cannot be avoided.
Preparation
Before doing any electrical welding work related to
body mounting work, turn off the starter switch and
disconnect the battery cable from the negative
terminal.
Put the ground for the welder close to the position you
are welding.
When painting work
• Mask the radar unit and radar cover so no paint
gets on them.
• Remove the radar unit from the vehicle before
forced drying the area around the radar unit.
If you remove the radar unit
After you have removed the radar unit from the
vehicle, have the radar adjusted at MITSUBISHI FUSO
TRUCK&BUS CORPORATION.
If you drop the radar unit
The radar unit is a precision component. You must
replace it if it is subjected to physical shock, such as
being dropped.
Built body components
Do not install built body components in front of the
radar. Doing so could cause false alarms or
malfunctions.
Do not install a license plate frame (number plate
frame).
To Next Page
Loading...