151
8.1 Electrical system
8 Electrics/electronics
MITSUBISHI FUSO body/equipment mounting directives for FE Issue date: 20. 10. 2020
! Only print out complete sections from the current version
8.1.3 Starter switch
• The starter switch uses weak current contacts. Do
not add any wiring to the line connected to the
starter switch.
• In case the use of a power source linked to the
starter switch is unavoidable, be sure to connect to
the appropriate output terminal for additional
wiring provided on the signal detection and
actuation module control unit via the connector for
body equipment.
Regarding the output terminals for additional
wiring provided on the signal detection and
actuation module control unit, see "8.1.2 Signal
detection and actuation module-related parts"
É 8.1.2.
To Next Page
Loading...