50
4 Technical threshold values for planning
4.6 Vehicle body incline
MITSUBISHI FUSO body/equipment mounting directives for FE Issue date: 20. 10. 2020
! Only print out complete sections from the current version
Spacer part number and insertion position
• Clamp the spring to the axle by tightening the U-
bolt to the specified torque.
• Re-check the tilt, and if the amount of correction is
insufficient, insert a spacer at the front wheel as
well.
• Place chocks beneath the rear wheels, then
jack up the rear axle in order to firmly support
the frame.
• Insert a spacer (MC110153) between the front
axle and the left or right front wheel, whichever
is lower (the tilt will be corrected by approxi-
mately 5 mm).
If it is still necessary to correct the vehicle tilt even
after performing the above corrective procedure,
please contact the department responsible.
É 2.1.
Spacer part number
(All t = 4.5)
Insertion position of rear wheel spacer
In the case of
(Right falling)
In the case of
(Right rising)
MB161776 Below right spring Below left spring
i Additional information
If the length of the U-bolt is insufficient, replace the
bolt with one which is between one and two sizes
longer.
i Additional information
• The center bolt for the spring does not need to
be loosened.
• If the length of the center bolt is insufficient,
replace the bolt with one which is between one
and two sizes longer.
To Next Page
Loading...