G
Surface
Altitude
Slant
●Altitude calculated as
either straight
line
distance (slant) or surface
distance on a map can
also be selected
(3/3)
Alert setting when the aircraft approaches
1. Access the second page by pushing S1.
Move the cursor to the ↓ALERT item and
touch the RTN button to switch to the data
input mode.
2. Select the ACT mode by scrolling the touch
sensor.
3. Touch the RTN button. (To terminate the input
and return to the original state, touch the S1
button.)
4. Move the cursor to the ↓THRESHOLD [0m]item
and touch the RTN button to switch to the
data input mode.
5. Ajust the rate by scrolling the touch sensor.
*When the RTN button is touched for one second, the rate is
reset to the initial value.
6. Touch the RTN button. (To terminate the input
and return to the original state, touch the S1
button.)Slant and surface distance
Two displays methods, straight line distance
and surface distance, can be selected as shown
above.
1. Select page 3 by touching the S1 button
twice from the “DISTANCE” screen.
2. Select <SLANT> <SURFACE> next to “MODE”,
scroll to the desired method and touch the
RTN button.
● Select [DISTANCE] in the TELEMETRY screen by touching
the RTN button. And S1 button is touched twice.
To Next Page
Loading...