SBUS SERVO
SBUS servo setting.
An S.BUS servo can memorize the channel
and various settings you input. Servo setting
can be performed on the T14SG screen by
wiring the servo as shown in the figure.
● Select [SOUND] at the system menu and access
the setup screen shown below by touching the
RTN button.
Scrolling
● Moving cursor
● Selecting mode
Servo ID number
Individual ID numbers are memorized for your
S.BUS servos in your T14SG. When a servo is used,
the servo ID number is automatically read by the
transmitter.
If you use multiple S.BUS servos and
do not want to change the settings on all that are
mounted in a fuselage, only the desired servo in the
group can be set by entering the ID of that specic
servo.
* S9070SB cannot be arranged by T14SG.
* With some S.BUS servos, there are some functions with cannot be
used. If a function cannot be used, the display screen will change.
(Only the function which can be used by a servo is displayed.)
* After reading completion, with connection of the above
figure, if a stick is moved, the test of operation of the
servo can be operated and carried out.
Procedure for changing S.BUS servo setting
1. Select [SBUS SERVO] of the System Menu.
2. Wire the servo as shown in the gure above.
3. Press [RECALL] on page 3(S1 is pushed twice).
The ID and current setting of that servo are
displayed. ([RECALL] is chosen
⇒
RTN is
pushed
⇒
RTN is pushed for 1 second)
4. When multiple servos are connected change
[INH] at the right side of the ID number on the
screen to [ACT] and enter the ID of the servo
you want to set.
5. Set each item. (Please see the next page.)
6. Press [WRITE] on page 3([WRITE] is
chosen
⇒
RTN is pushed
⇒
RTN is pushed for
1 second). The settings are changed.
Push [INIT.], if you would like to initialize a
setup of a servo. ([INIT.] is chosen
⇒
RTN is
pushed
⇒
RTN is pushed for 1 second)
S.BUS/S.BUS2
Servo
Battery
T14SG
3-way hub
or
Y-harnesses
To Next Page
Loading...