FUTABA 14SG S.Bus2 - Gyro (for GY Type Gyro)

158
<Functions of Model Menu (Helicopter Functions)>
●Selectthe functionname
andreturntothe Model
menubytouchingthe
RTNbutton. Orthe
HOME/EXIT buttonis
pushed.
<SensorTouch™>
RETURN
GYRO mixing
This function used to adjust gyro sensitivity.
The sensitivity and operation mode (Normal mode/
AVCS mode) can be set for each condition.
The gyro sensitivity can be switched with each
condition or the switch. (5 sensitivities)
*Compatible with 3 axis gyro(CGY750).
●Select[GYRO]attheModelmenuandaccessthe
setupscreenshownbelowbytouchingtheRTN
button.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
Note: When using the [Gyro2]/[Gyro3] function,
assign [Gyro2]/[Gyro3] to any channel on the
function screen.
Always set to [--] both (Control) and (Trim) for
the [Gyro] function at the Function menu in
the Linkage menu.
(Currently selected condition name)
●Modeselection:
 [AVCS]/[NORM]
●Gyrotypeselection:
 [GY]/[NORM]
●Setupscreenselection
●ON:(initialsetting)
●FinetuningVRsettings
●Gyrosensitivityadjustment
●Condition/Switchselection
●Theeditconditionscanbe
changedbytouchingthe
S1button.
*When the rate switching setting of
all the gyros is “Switch”, the edit
conditions are not displayed.
●Theeditratecanbechangedbyoperating
theeditratebutton.
*When the rate switching setting of all the gyros is
“COND”, the edit rate button is not displayed.
●WhentheGYROfunctionbuttonisselected,
eachGYROdetailedsettingscreen
appears.