FUTABA 14SG S.Bus2 - S.BUS Wiring Example

29
<Before Use>
S.BUS Wiring example
Battery
Battery
GY520
Extension
cord
Switch
Switch
Terminal box
HUB
HUB HUB
HUB
HUB
HUB
HUB
（Another power supply）
HUB
S.BUS Servo
S.BUS Servo
Receiver
●S.BUSServo
Since the channel number is memorized by
the S.BUS itself, any connector can be used.
When the SBD-1 (sold separately) is used,
ordinary servos can be used with the
S.BUS system.
●Whenseparatepowersupplyused
When a large number of servos are used or
when high current servos are used, the servos
can be driven by a separate power supply by
using a separate Power Supply 3-way Hub.
●
Terminal box
Four connectors can be inserted
Three connectors can be
inserted.
Used when using a separate
power supply battery.
S.BUS
Port
(8/SB)
Orange
Green
*When using 8/SB as S.BUS, you must set the receiver to
Mode B or Mode D. See Mode Chart page 25.
Warning
Power supply
Please make sure that you use a
battery that can deliver enough
capacity for the number and kind of
servos used. Alkaline batteries cannot
be used.