FUTABA 14SG S.Bus2 - Sensor:relocate; Sensor:set Slot

104
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
RTN button. Or the
HOME/EXIT button is
pushed.
<SensorTouch™>
RETURN
This function secures contiguous unused slots
by rearranging the registration state when sensor
registration and deregistration are performed
repeatedly and the unused slots are fragmented.
Relocate of sensors to be used
1. Connect all the sensors and receiver
batteries to be used to the T14SG through a
hub as shown in the gure above.
2. Move the cursor to “RELOCATE” on page 7 of
the [SENSOR] screen.
3. Touch the RTN button.
This procedure changes the slot No. of one
registered sensor.
Sensor slot change
1. Connect the sensor and receiver battery to
be changed to the T14SG through a hub as
shown in the gure above.
2. Move the cursor to “SET SLOT” on page 7 of
the <Sensor> screen.
3. Touch the RTN button. A sensor details screen
appears.
4. Move the cursor to “LOAD” and touch the
RTN button.
5. The current start slot is displayed. Move the
cursor to the number of the start slot and
change it to the desired value.
（
Cannot be
set to a slot that cannot be allocated like the
table of all pages.
）
6. Move the cursor to “WRITE” and touch the
RTN button.
Allthesensorstobeusedareconnected.
SENSOR SENSOR
3-way hub
or Y-harnesses
Receivers
Battery
T14SG
SENSOR SENSOR SENSOR
SENSOR : RELOCATE
SENSOR : SET SLOT
3-way hub
or Y-harnesses
Receivers
Battery
T14SG
SENSOR
This page is set when using multiple telemetry sensors of the same type.
This page is set when using multiple telemetry sensors of the same type.
● Call page 7 by touching the S1 button 6 times from
the [SENSOR] menu.