FUTABA 14SG S.Bus2 - Throttle MIX

156
<Functions of Model Menu (Helicopter Functions)>
●Selectthe functionname
andreturntothe Model
menubytouchingthe
RTNbutton. Orthe
HOME/EXIT buttonis
pushed.
<SensorTouch™>
RETURN
THROTTLE MIX
This function corrects slowing of engine speed
caused by swash plate operation during aileron
or elevator operation. The method of applying
clockwise or counterclockwise torque when
pirouetting can also be corrected.
Setting example
●AILtoTHRmixingcounteractsthelagin
engineRPM'swhenanaileroninputisgiven
tothehelicopter.Engineover-speeding
canbeadjustedindependentlyforthe
rightaileronandleftaileroninputsutilizing
Rates1and2.
●Select[THROTTLEMIX]atthe Model
menuandaccessthesetupscreen
shownbelowbytouching theRTN
button.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
(Currently selected condition name)
Setting method
●Activate the mixing
 Whenusingthisfunction,movethecursorto
the[ACT]itemandtouchtheRTNbuttonto
switchtothedatainputmode.
 SelecttheACTmodebyscrollingthetouch
sensor.
*The display blinks.
 TouchtheRTNbuttontoactivatethemixing
andreturntothecursormode.(ONis
displayed.)
 [Switchselection]
 When[[--]]isset,theswashmixingfunction
isalwaysactiveandoperatedbymerely
selectingthecondition.
 Whensettingan[ON]/[OFF]switch,movethe
cursortothe[SW]itemandtouchtheRTN
buttontocalltheselectionscreen.Setthe
switchanditsONposition.
*For a description of the switch selection method, see the
description at the back of this manual.
●Mixing rate adjustment
 Movethecursortothemixingrateitemyou
wanttocorrectandtouchtheRTNbutton
toswitchtothedatainputmode.Adjustthe
rateindependentlybyscrollingthetouch
sensor.
 Initialvalue:0%
 Adjustmentrange:-100~+100%
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
 TouchtheRTNbuttontoendtheadjustment
andreturntothecursormode.
●Operation mode setting
 Movethecursortothe[MODE]itemand
touchtheRTNbuttontoswitchtothedata
inputmode.
 Select the operation modebyscrollingthe
touchsensor.
*The display blinks.
 CTRMmode:Correctsnearthecenteronly.
 LIN.mode:Correctsthecompleterange.
 TouchtheRTN buttontochangethe
operationmodeandreturntothecursor
mode.
●Conditionselection