FUTABA 14SG S.Bus2 - PIT to RUD (Revolution MIX)

157
<Functions of Model Menu (Helicopter Functions)>
●Selectthe functionname
andreturntothe Model
menubytouchingthe
RTNbutton. Orthe
HOME/EXIT buttonis
pushed.
<SensorTouch™>
RETURN
PIT to RUD mixing (Revolution mixing)
Use this mix when you want to suppress the
reaction torque generated by main rotor pitch and
speed changes during pitch operation. Adjust so
that the nose does not move in the rudder direction.
<Normal condition mixing curve>
 Themixingcurverateshouldbestarted
usingsmallervalues.
 Forarotorwithaclockwiseoperation
direction,whenpitchwasinputattheplus
side,settheseparameters so thatmixing
isintheclockwisedirection.First,trimat
hoveringandthenadjusttheneutral
position.
1.Adjustmentbetweenslowandhovering
 Repeatedlyhoverfromtakeoffandland
ataconstantratematchedtoyourown
rhythm.Thenadjustthepitchsothatthe
noseofthehelicopterremainssteady
whenthethrottleisraisedandlowered.
2.Throttlehighside(climbinganddivingfrom
hovering)
 Repeatclimbinganddivingfromhovering
ataconstantratematchedtoyourown
rhythmandadjustthepitchsothatthenose
doesnotdeflectwhenthe throttle israised
andlowered.
Note: When a GY Series or other heading hold
gyro is used, since correction is performed by
the gyro, this mix is not utilized. If this function
is used when the gyro operation mode is the
AVCS mode, the neutral position will change.
<Idle up condition mixing curve>
 Setthemixingratesothattherudderdirection
athigh-speedightis straightahead.Adjust for
eachconditionused.
●Select[PITtoRUD]attheModel
menuandaccessthesetup screen
shownbelowbytouchingtheRTN
button.
(Currently selected condition name)
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Tonextpage
Setting method
●Activate the mixing
 Whenusingthisfunction,movethecursorto
the[ACT]itemandtouchtheRTNbuttonto
switchtothedatainputmode.
 SelecttheACTmodebyscrollingthetouch
sensor.
*The display blinks.
 TouchtheRTNbuttontoactivatethemixing
andreturntothecursormode.(ONis
displayed.)
●5-point curve setting
 Movethecursortothecurveratesetting
itemyouwantto adjust andtouchtheRTN
buttontoswitchtothedatainputmode.
 Adjusttheratebyscrollingthetouchsensor.
 Initialvalue:P1~P5:0%
 Adjustmentrange:-100%~+100%
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
 TouchtheRTNbuttontoendtheadjustment
andreturntothecursormode.
 Repeatthisprocedureforeachpoint.
●Pitch curve copy function
 MovethecursortoCOPYitemandtouchthe
RTNbuttontoswitchtothedatainputmode.
Selectthecopydestinationconditionby
scrollingthetouchsensorandtouchtheRTN
button.Selectthe[YES]andtouchtheRTN
button.