FUTABA 14SG S.Bus2 - Throttle Hold

154
<Functions of Model Menu (Helicopter Functions)>
●Selectthe functionname
andreturntothe Model
menubytouchingthe
RTNbutton. Orthe
HOME/EXIT buttonis
pushed.
<SensorTouch™>
RETURN
THR HOLD
This function sets the throttle cut position for
auto rotation. The throttle servo operating speed
can be adjusted. (Speed)
Note: Initially, this setting does not assign the
throttle hold switch. Prior to adjusting the
parameters for the throttle hold, we suggest
designating a throttle hold switch. To do so,
access the Condition menu within the Model
menu options.
●Servospeed
Setting method
●Hold condition switch selection
 UsetheConditionselectmenuoftheModel
menutoassigntheholdconditionswitch.
 Selectionexample:SG
●Hold position adjustment
 Movethecursortotheholdpositionitem
andtouchtheRTNbuttontoswitchtothe
datainputmode.
 Adjusttheratebyscrollingthetouchsensor.
 Initialvalue:17%
 Adjustmentrange:0%~50%
*Hold position sets the throttle cut position. Adjust it so that
the carburetor is completely closed.
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
 TouchtheRTNbuttontoendtheadjustment
andreturntothecursormode.
●Servo speed setting
 Movethecursortotheservospeeditemand
touchtheRTNbuttontoswitchtothedata
inputmode.
 Adjusttheratebyscrollingthetouchsensor.
 Initialvalue:0
 Adjustmentrange:0~27(maximumdelay)
*When the RTN button is touched for one second, the rate is
reset to the initial value.)
 TouchtheRTN button to return tothecursor
mode.
●Select[THRHOLD]attheModelmenu
andaccessthesetupscreenshown
belowbytouchingtheRTNbutton.
Scrolling
●Movingcursor
●Selectingmode
●Adjustingvalue
●Holdpositionsetting
●Holdposition
●Currentposition
Operation precautions
Warning
When actually starting the engine and flying,
always set the idle up condition switch to OFF
and start the engine at idle.