FUTABA 14SG S.Bus2 - Telemetry:distance

99
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
RTN button. Or the
HOME/EXIT button is
pushed.
<SensorTouch™>
RETURN
TELEMETRY : DISTANCE
Displaying data from the distance
Distance is a screen that displays and sets the
altitude data from an SBS-01G (GPS Sensor) sold
separately. The distance to the airborne aircraft
can be read by the transmitter. When the aircraft
ies outside (inside) the set distance the operator is
alerted by an alarm and vibration.
*The GPS sensor sold separately is necessary. Mount and
connect the sensor in accordance with the sensor instruction
manual.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest14CH mode can use all the telemetry functions.
● Select [DISTANCE] in the TELEMETRY screen and
access the setup screen shown below by touching
the RTN button.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
●Current distance
●Distance alarm setting
range 1m
～
5,000m
*Alarm when the aircraft moves far
away.
(↑THRESHOLD > ↓THRESHOLD)
●Distance alarm setting range 0m
～
4,999m
(↑THRESHOLD > ↓THRESHOLD)
● Maximum distance after
transmitter was turned on.
● The ↓arrow shows
that an alarm is
generated when the
distance drops below
the set value.
● The ↑arrow shows
that an alarm is
generated when
the set value is
exceeded.
First, the set of a reference is required.
1. The model and transmitter to which the GPS
sensor was connected are turned on.
2. It waits until the GPS receiving accuracy
displayed on a screen becomes three.
3. Move the cursor to the [SET] of "REFERENCE"
item and touch the RTN button to switch to
the data input mode.
4. Touch the RTN button. (To terminate the input and
return to the original state, touch the S1 button.)
*Now, the position of the present model was set to 0 m.
Alert setting when aircraft goes too far
1. Move the cursor to the ↑ALERT item and
touch the RTN button to switch to the data
input mode.
2. Select the ACT mode by scrolling the touch
sensor.
3. Touch the RTN button. (To terminate the input
and return to the original state, touch the S1
button.)
4. Move the cursor to the ↓THRESHOLD [1,000m]
item and touch the RTN button to switch to
the data input mode.
5. Ajust the rate by scrolling the touch sensor.
*When the RTN button is touched for one second, the rate is
reset to the initial value.
6. Touch the RTN button. (To terminate the input
and return to the original state, touch the S1
button.)
TYPE1
TYPE2
TYPE3
TYPE4
"Vibes" type
*A GPS sensor must be installed in the aircraft.
If the following types are selected, the
transmitter will vibrate during the warning.
●Press the S1 button to advance to the next page.
G
G
●It is the receiving accuracy from
a GPS Satellite. Please wait until
it becomes 3 displays, and push
[REFERENCE].