FUTABA 14SG S.Bus2 - Telemetry:temp

94
<Functions of Linkage Menu>
● Select the function name
and return to the Linkage
menu by touching the
RTN button. Or the
HOME/EXIT button is
pushed.
<SensorTouch™>
RETURN
TELEMETRY : TEMP.
Displaying data from the temperature
TEMP. is a screen which displays/sets up
the temperature information from an optional
temperature sensor.
The temperature of the model (engine, motor,
battery etc.) which is ying can be displayed.
If it becomes higher or lower than the setting an
alarm and/or vibration will alert you.
*It cannot be used in FASST mode and S-FHSS mode.
*Only receiver voltage and EXT voltage can be used in
FASSTest12CH mode.
*The FASSTest14CH mode can use all the telemetry functions.
● Select [TEMP.] in the TELEMETRY screen and access
the setup screen shown below by touching the
RTN button.
●Press the S1 button to advance to the next page.
Scrolling
● Moving cursor
● Selecting mode
● Adjusting value
● To next page
● Temperature
● The maximum and the minimum when
powering ON are shown.
● ↓ An downward arrow
will show that an
alarm will sound when
the temperature
drops below the set
value.
● ↑ An upward arrow
will show that an
alarm will sound when
the temperature rises
above the set value.
Alert set : Hot warning
1. Move the cursor to the ↑ALERT item and
touch the RTN button to switch to the data
input mode.
2. Select the ACT mode by scrolling the touch
sensor.
3. Touch the RTN button. (To terminate the input
and return to the original state, touch the S1
button.)
4. Move the cursor to the ↑THRESHOLD [+100
℃
]
item and touch the RTN button to switch to
the data input mode.
5. Ajust the rate by scrolling the touch sensor.
Initial value: +100
℃
Adjustment range: 1
℃
~200
℃
(↑THRESHOLD > ↓THRESHOLD)
*When the RTN button is touched for one second, the rate is
reset to the initial value.
6. Touch the RTN button. (To terminate the input
and return to the original state, touch the S1
button.)
Alert set : Low-temperature warning
1. 2/2 page is accessed by pushing S1. Move
the cursor to the ↓ALERT item and touch the
RTN button to switch to the data input mode.
2. Select the ACT mode by scrolling the touch
sensor.
3. Touch the RTN button. (To terminate the input
and return to the original state, touch the S1
button.)
4. Move the cursor to the ↓THRESHOLD [+0
℃
]
item and touch the RTN button to switch to
the data input mode.
5. Ajust the rate by scrolling the touch sensor.
Initial value: +0
℃
Adjustment range: 0
℃
~199
℃
(↑THRESHOLD > ↓THRESHOLD)
*When the RTN button is touched for one second, the rate is
reset to the initial value.
6. Touch the RTN button. (To terminate the input
and return to the original state, touch the S1
button.)
TYPE1
TYPE2
TYPE3
TYPE4
"Vibes" type
If the following types are selected, the
transmitter will vibrate during the warning.
*A temperature sensor must be installed in the aircraft.