14
<Before Use>
Transmitter's Antenna:
As with all radio frequency transmissions, the
strongest area of signal transmission is from the
sides of the transmitter's antenna. As such, the
antenna should not be pointed directly at the model.
If your flying style creates this situation, easily
move the antenna to correct this situation.
LED (Left)
Displays the "non-default condition" warning.
• Blinking
Power switch is turned on when any
condition switch is activated (in the ON
state).
LED (Right)
Displays the state of radio frequency
transmission.
• Off
Radio waves are in the OFF state.
• On
Radio waves are being transmitted.
• Blinking
Range check mode.
Monitor LED display
The status of the transmitter is displayed by LED
at the bottom left and right sides of the "T14SG"
logo.
•Rotating antenna
The antenna can be rotated 90 degrees and angled
90 degrees. Forcing the antenna further than this
can damage it. The antenna is not removable.
90°
90°
Caution
Please do not grasp the transmitter's
antenna during ight.
Doing so may degrade the quality of the RF
transmission to the model
Do not carry the transmitter by the
antenna.
There is the danger that the antenna wire will break and
operation will become impossible.
Do not pull the antenna forcefully.
There is the danger that the antenna wire will break and
operation will become impossible.
Low power
High power High power
It is not good for there to
be a model on ight in the
direction tip of an antenna.
If you have a transmitter
at an angle of a figure, an
antenna will be good to use
it, bending 90 degrees.
To Next Page
Loading...