FUTABA 14SG S.Bus2 - S.BUS;S.BUS2 Installation

28
<Before Use>
S.BUS/S.BUS2 Installation
This set uses the S.BUS/S.BUS2 system. The wiring is as simplied and clean mounting as possible, even
with models that use a large number of servos. In addition, the wings can be quickly installed to the fuselage
without any erroneous wiring by the use of only one simple wire, even when there are a large number of servos
used.
●When using S.BUS/S.BUS2, special settings and mixes in your transmitter may be unnecessary.
●The S.BUS/S.BUS2 servos memorize the number of channels themselves. (Settable with the T14SG)
●The S.BUS/S.BUS2 system and conventional system (receiver conventional CH used) can be mixed.
Receiver:R7008SB
Battery:FR2F1800(Optional)
Switch:HSW-L
Throttleservo:BLS173SV(Optional)
Aileronservo:BLS174SV×2(Optional)
Elevatorservo:BLS173SV×2(Optional)
RudderServo:BLS175SV×1(Optional)
HUB×3(Optional)

Receiver:R7008SB
Servo:S3172SV×9(Optional)
HUB×4(Optional)
S.BUS Gliderusageexample
S.BUSAerobaticplaneusageexample