FUTABA 14SG S.Bus2 - Home Screen

35
<Basic Operation>
Up/Down timer (ST1, ST2)
•Timerisdisplayedhere.
Touch the RTN button at the [xx]:[xx.
xx] item to start/stop the timer.
• Usethecursortohighlightthis,then
touch the RTN button at the ST1 or ST2
item to call the timer set-up screen.
*See the description at the back of this manual.
Home screen
Digital trim (T1 to T4)
• Trimpositionisdisplayedhere.
• Youcanselectthedisplayunit
on the home screen on the
T1-T4 setting screen within the
linkage menu.
Model Name
•Themodelnamethat
is currently used is
displayed here.
•Usethecursorto
highlight this, then
touch the RTN button
to call the model
select set-up screen.
User's name
System timer
•Thisshowstheaccumulatedtimesince
the latest reset. (Hour):(Minute)
•Usethecursortohighlightthis,then
touch the RTN button for one second
to reset the system timer.
Use the touch sensor to select the following display area to call each setting screen, and touch the RTN
button. The setting screen appears.
RF indicator
Battery Indicator
• Whenthebatteryvoltage
reaches 5.2V(Change in
Warning Menu), the alarm
will beep. Land your aircraft
immediately.
System mode
•System(FASSTest14CHetc.)
mode is displayed here.
•Usethecursortohighlightthis,
then touch the RTN button
to call the frequency set-up
screen.
2
nd
Home screen
•TouchtheRTNbuttonat
the clock icon to call the
2
nd
home screen (large
size timer).
Model timer
•Thisshowstheaccumulated time
since the latest reset. (each model)
(Hour):(Minute)
•Usethecursortohighlightthis,
then touch the RTN button for one
second to reset the model timer.
Key lock
• TouchtheS1buttonorpushthe
HOME/EXIT button for one second to
lock/unlock the key operation.
In the key lock mode the key icon is
displayed here.
Model type
SD card indicator
Condition name (Heli/Glider)
•Inthenormalcondition,movethe
cursor to the condition name and
touch the RTN button. The condition
name is changed and blinks.
It is possible to operate the digital
trim in all conditions.
VPP condition # (Air)
•WhenVPPfunction is assigned toa
channel,thecurrentVPPcondition
# is displayed here.