FUTABA 14SG S.Bus2 User Manual

54
<Functions of System Menu>
● Select the function name
and return to the System
menu by touching the
RTN button
.
Or the
HOME/EXIT button is
pushed.
<SensorTouch™>
RETURN
LCD contrast adjustment
1. Select "CONTRAST" and touch the RTN button
to switch to the data input mode and adjust
the contrast by scrolling the touch sensor.
"CONTRAST": Adjust the contrast to the
desired value while watching the screen
display.
Setting range: (Lighter) 0 to 15 (Darker)
Initial value: 5
*When you want to reset the value to the initial state, touch
the RTN button for one second.
2. Touch the RTN button to end adjustment and
return to the cursor mode.
Back-light brightness adjustment
1. Select "BRIGHTNESS" and touch the RTN
button to switch to the data input mode and
adjust the back-light brightness by scrolling
the touch sensor.
"BRIGHTNESS": Adjust the brightness to the
desired value while watching the screen
display.
Setting range: OFF, 1 to 20(Lighter)
Initial value: 10
*When you want to reset the value to the initial state, touch
the RTN button for one second.
DISPLAY
LCD and back-light adjustment, unit system
LCD contrast, back-light brightness and back-
light off-timer adjustment are possible:
Moreover, a display unit can be chosen from the
metric system or yard/pound.
2. Touch the RTN button to end adjustment and
return to the cursor mode.
Back-light off-timer
1. Select "OFF TIMER" and touch the RTN button
to switch to the data input mode and adjust
the back-light off-timer by scrolling the touch
sensor.
"OFF TIMER": Adjust the time when the back-
light turns off after operating the touch
sensor.
Setting range: 10 to 240 sec (each 10 sec),
OFF (always on)
Initial value: 10 sec
*When you want to reset the value to the initial state, touch
the RTN button for one second.
2. Touch the RTN button to end adjustment and
return to the cursor mode.
Unit system adjustment
1. Select "UNIT SYS." and touch the RTN button
to switch to the data input mode and adjust
the unit by scrolling the touch sensor.
Setting range: (METRIC) or (YARD/POUND)
2. Touch the RTN button to end adjustment and
return to the cursor mode.
● Select [DISPLAY] at the system menu and access
the setup screen shown below by touching the
RTN button.
Scrolling
● Moving cursor
● Adjusting value

FUTABA 14SG S.Bus2 Specifications

General

Channels	14
Frequency	2.4GHz
Telemetry	Yes
S.Bus2 Support	Yes
User Menu	Yes
Compatibility	FASST, FASSTest, S-FHSS
Display	LCD
Model Memory	30