FUTABA 14SG S.Bus2 - Page 159

159
<Functions of Model Menu (Helicopter Functions)>
Setting method
●Gyro type selection
 Movethecursortothegyrotypeselection
itemandtouchtheRTNbuttontoswitchto
thedatainput mode. Selectthegyrotype
byscrollingthetouchsensor.
 [GY]:WhenaFutabaGYgyroisused
 [NORM]:WhenotherthanFutabaGYgyrois
used
 TouchtheRTNbuttontochangethegyro
typeandreturntothecursormode.
*When a Futaba GY gyro is used and [GY] type is selected,
the sensitivity set value is directly read in both the AVCS
and NORM modes.
●Operation mode selection (GY gyro)
 Movethecursortotheoperationmode
selectionitemandtouchtheRTNbutton
toswitchtothedatainputmode.Select
theoperationmodebyscrollingthetouch
sensor.
 [AVCS]:AVCSmode
 [NORM]:Normalmode
 TouchtheRTN buttontochangethe
operationmodeandreturntothecursor
mode.
●Sensitivity setting
 Movethe cursor to the rate item and touch
theRTNbutton toswitchtothedatainput
mode.
 Adjustthesensitivitybyscrollingthetouch
sensor.
 Initialvalue:80%
 Adjustmentrange:0~100%
*When the RTN button is touched for one second, the
sensitivity is reset to the initial value.)
 TouchtheRTN button to return tothecursor
mode.
●Fine tuning VR settings
 Movethecursortothe[--]itemandtouch
theRTNbuttontoaccesstheselection
screen.Selectthecontrol.
*For a description of the switch selection method, see the
description at the back of this manual.
 Movethe cursor to the rate item and touch
theRTNbutton toswitchtothedatainput
mode.
 Adjustthetrimratebyscrollingthetouch
sensor.
 Initialvalue:0%
 Adjustmentrange:-20~+20%
*When the RTN button is touched for one second, the
sensitivity is reset to the initial value.)
 TouchtheRTN button to return tothecursor
mode.
<EXAMPLE>Rudder gyro gain is changed with
a switch (SF) irrespective of condition.
Generally,gainisinterlockedwithcondition
andchangesarate.
Howtochangetworatesinthesame
conditionhere.
1.Select[GYRO] attheModelmenuand
accessthesetupscreenshownbelowby
touchingtheRTNbutton.
2.Movethecursortothe[COND]item
andtouchtheRTNbuttontoaccessthe
selectionscreen.Selectthe[SW].Touchthe
RTNbuttontoreturntothecursormode.
3.#numbershowsthepresentswitchstate.In
thestateof#1acursorismovedto[--]and
RTNispushed.
4.[SF]ischosenby[H/WSELECT]andthena
topisturnedON.
5.[TYPEGY]and[RATE]ofastateof"#1=SF
top"aresetup.
6.Itisasetupof"#2".Movethecursortothe
[#1]itemandtouchtheRTNbuttonto
accesstheselectionscreen.Selectthe[#2].
TouchtheRTNbuttontoreturntothecursor
mode.
SF : Top = #1
●
Thenumber
ofaSWstate