FUTABA 14SG S.Bus2 - Page 149

149
<Functions of Model Menu (Helicopter Functions)>
Normal Curve Idle-up 1 Curve Idle-up 2 Curve Hold Curve
●Pitch Curve (Example)
The screens shown below are curves created by
entering the pitch rate at low, center, and high side (3
points or 5 points) at each condition.
When actually creating a curve, input the rate
specied by the model (or the reference value).
Curve setting examples
Pitch Trim (Hovering pitch, high pitch, low pitch)
[Hoveringpitchtrimsetting]
Hovering pitch trim
The Hovering Pitch trim function trims the pitch
near the hovering point. Normally, it is used with
the hovering condition. The hovering pitch can be
ne tuned for changes in rotor speed accompanying
changes in temperature, humidity, and other ight
conditions. Adjust the hovering pitch so that
rotor speed is constant. This function can be used
together with the Hovering Throttle Trim function
for more precise operation.
Setting method
●SetthefunctiontoACT[ON].(initialsetting)
●Selecttheadjustmentknob.
 Selectionexample:LD(initialsetting)
●Thetrimoperationmode(Mode:CTRM/
NORM)canbeselected.
 CTRM mode:Maximumamountofchange
nearcenterby centertrimoperation
(recommended)
 NORM mode:Normaltrim(parallel
movementtrim)operation.Theadvantage
ofusingthismodeisthat the hovering pitch
canbeadjustedwithoutchangingthe
curve.
●Thetrimratecanbeadjustedandthe
operationdirectioncanbechanged.
●Trimadjustmentrange(Range)setting
 Whenthisvalueismadesmall,trimcanonly
beusednearthecenter.