FUTABA 14SG S.Bus2 - Page 162

162
<Functions of Model Menu (Helicopter Functions)>
●Diplay mode selection
*When [rpm] mode is selected above setting, the display
mode can be selected.
* There is no change in the transmitter output even when the
"MODE" is changed. Calibration should be performed via
the governor.
* In order to use the Governor function of the T14SG, it is
necessary to change the settings on the governor for the low
side 700 rpm mode.
WhentheMODEoftheGovernorscreen's
modelmenuischanged,thechangeisalso
indicatedon-screen.
The chart below indicates the mode percentage and
the corresponding RPM.
MODE 0％ 50％ 100％ 110％
1000-2000rpm 1000rpm 1500rpm 2000rpm 2100rpm
1000-2500rpm 1000rpm 1500rpm 2500rpm 2700rpm
1000-3500rpm 1000rpm 1500rpm 3500rpm 3900rpm
700-2000rpm 700rpm 1500rpm 2000rpm 2100rpm
700-2500rpm 700rpm 1500rpm 2500rpm 2700rpm
700-3500rpm 700rpm 1500rpm 3500rpm 3900rpm
●Fine tuning VR settings
 Movethecursortothe[--]itemandtouch
theRTNbuttontoaccesstheselection
screen.Selectthecontrol.
*For a description of the switch selection method, see the
description at the back of this manual.
 Movethe cursor to the rate item and touch
theRTNbutton toswitchtothedatainput
mode.
 Adjustthetrimratebyscrollingthetouch
sensor.
 Initialvalue:0%(0rpm)
 Adjustmentrange:-20~+20%(-200~+200rpm)
*When the RTN button is touched for one second, the
sensitivity is reset to the initial value.)
 TouchtheRTN button to return tothecursor
mode.
<EXAMPLE>RPM rate is changed with a
switch (SF) irrespective of condition.
Generally,RPMrateisinterlockedwith
conditionandchangesarate.
Howtochangetworatesinthesame
conditionhere.
1.Select[GOVERNOR]attheModelmenu
andaccessthesetupscreen shown below
bytouchingtheRTNbutton.
2.Movethecursortothe[COND]item
andtouchtheRTNbuttontoaccessthe
selectionscreen.Selectthe[SW].Touchthe
RTNbuttontoreturn to thecursormode.
And[INH]issetto[ACT].
3.#numbershowsthepresentswitchstate.In
thestateof#1acursorismovedto[--]and
RTNispushed.
4.[SF]ischosenby[H/WSELECT]andthena
topisturnedON.
5.[MODE]and[RATE]ofastateof"#1=SF
top"aresetup.
6.Itis asetupof"#2".Movethecursorto
the[#1]itemandtouchtheRTNbutton
toaccesstheselectionscreen.Selectthe
[#2].TouchtheRTNbuttontoreturntothe
cursormode.And[INH]issetto[ACT].
SF : Top = #1
●
Thenumber
ofaSWstate