FUTABA 14SG S.Bus2 - Page 165

165
<Appendix>
Timer setting
●Up timer/down timer setting
 Movethecursortothe[MODE]itemand
touchtheRTNbuttontoswitchtothedata
inputmode.
 Selectthemodebyscrollingthetouchsensor
andtouchtheRTNbutton.
 [UP]:Uptimer
 [DOWN]:Downtimer
 [HOUR]:Hourmodetimer
●Timer time setting
 Movethecursortothe[ALARM]itemand
touchtheRTNbuttontoswitchtothedata
inputmode.
 Setthetimebyscrollingthetouchsensor.
 [00]:[00]:[min]:[sec]
 TouchtheRTNbuttontoendtheadjustment
andreturntothecursormode.
●Switch setting
 Movethecursortotheitemoftheswitchyou
wanttoset,accesstheswitchsetupscreen
bytouchingtheRTNbutton.Selecttheswitch
andONdirection.
[For a detailed description of the setting method, see [Switch
Setting Method] located on the next page.]
 [START]:Startswitch
 [STOP]:Stopswitch
 [RESET]:Resetswitch
●Memory setting
 Movethecursortothe[MEMORY]itemand
touchtheRTNbuttontoswitchtothedata
inputmode.
 Selectthemodebyscrollingthetouchsensor
andtouchtheRTNbutton.
 [OFF]:MemoryfunctionOFF
 [ON]:Modewherethetimerisnotresetwhen
turnedpoweroffandswitchedthemodel.
●A mode which sounds an alarm each minute
can be selected.
 Changethesettingusingthe"

"button(or
"

"button).
"

":Alarmsounds each minuteofthetime
elapsedfromtimerstart.(Conventional
mode)
"

":Alarmsounds each minuteofthetime
remaininguptothealarmtime.
Timer operation
● TimerST1andST2arestarted/stoppedby
pre-selectedstart/stopswitch.
● Toresetatimer,operatethepre-selected
resetswitch,ormovethecursortothe[RESET]
displayonthetimer screenandtouchthe
RTNbutton.